There are 3 components which make up the construction of an Anilox sleeve; aluminium outer, fibreglass inner and stainless steel end rings.
We source high quality drawn aluminium tubes to suit the required outside diameter. A fibreglass sleeve is then mounted onto the specific mandrel and the aluminium outer is bonded. Once cured, the outside diameter is rough turned and the ends machined to accept the stainless steel end rings.
Our end rings are manufactured inhouse and can be colour-coded. Machined on CNC lathes we hand-fit to every Anilox sleeve, ensuring they are tapped and threaded to provide outstanding resistance and durability. A unique gasket sealing technique protects the sleeve from chemical ingress into the aluminium causing substrate corrosion.
Our anilox rolls are manufactured from mild steel, stainless steel or aluminium.
Can’t find what you’re looking for?
For special requirements or technical questions, please complete ourenquiry form.
Any rolls sent in for refurbishment are assessed by our trained engineers who determine if repair is necessary or a full and new engraving is necessary. At no extra cost.
Can’t find what you’re looking for? If you have a specific requirement or technical question, please complete our enquiry form and a member of the team will be able to assist.
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.